TECHNICAL SPECIFICATIONS
- Measurement of alignment of horizontal machines in 3 points or more
up to 8 points for a greater reliability
- Measurement of trees disconnected and/or coupled on restricted angle
90°
- Dynamic Adjustments with the feet machines into horizontal or vertical,
the apparatus shows in real time the corrections of error during the
adjustment of the machine
- Research and evaluation of the wobbly foot, highlighted of the influence
of tightening in real time on the feet
- Recording of 10 files at least in the apparatus
- Impression of report/ratio on serial printer
- Transfer of the data on PC and relationship with the Alignment
software to defer
- Evolutionary Apparatus
- Possibility of changing the cable without changing the
transmitter-receiver.
- Posting of values X and Y with the micron to test the play in the
bearings and for the measurement of basic straightness |
- Distances from measurement of 45mm to 2000
mm;
- Size of the extensible target 11mm X 11mm;
- resolution of measurement 0,001 mm
- Protection of sensors IP 67
- Protection of instrument IP 65
- Broad Screen LCD 94 mm X 73 mm
- 25 hour Endurance approximately uninterrupted
- 1 set of 50 gauged and deburred holds especially designed for the
chock of the feet of engines
• 10 holds ep. 0.05mm
• 10 holds ep. 0.10mm
• 10 holds ep. 0.25mm
• 10 holds ep. 0.50mm
• 10 holds ep. 1mm
• matter: stainless
• opening of the holds for screw maximum M12
• thickness engraved on each hold
• case of arrangement
|
