TECHNICAL SPECIFICATIONS
1. Polyethylene supply tank
2. Dosing supply pump P1
- Flow rate: 0-16 L/h
3. Evaporator
- Borosilicate glass
- Equipped with a 316 L stainless steel coil
- Volume = 5 L
- Equipped with a capacitive level sensor that stops the heating at a low
level
4. Distillate receiver 3 L
- Borosilicate glass
5. Crystallizer
- Borosilicate glass
- Equipped with a stainless steel coil
- Volume : 5 L
6. Agitator
- Agitation speed: 50-1750 rpm
- ADF pneumatic motor
7. Heating group with vapour service
- Hot water circuit equipped with a centrifugal pump of 0.75 kW with an
ADF motor
- 2 single-tube exchangers
- Permit the regulation of the temperature in the evaporator and the hot
water circuit
- 2 electro valves and 1 PID regulator
- 1 Pt 100 |
8. Condenser for the evaporator ECH 1
- 1stainless steel section, 1 borosilicate glass section
9. Cooling coil for the crystalliser ECH 2
- 316 L stainless steel
10. Exchanger for the distillate
- Borosilicate glass
11. Filter
- Borosilicate glass of polypropylene
- Volume = 5 L
QV1 : Water flow rate on the evaporator's
exchanger (0-100 L/h)
QV2 : water flow rate on the crystalliser's coil
(0-60 L/h)
MESURES DE TEMPERATURES
T1 : Water inlet into the double shell of the condenser ECH 1
T2 : Water outlet of the condenser ECH 1
T3 : Water outlet of the crystalliser's coil
T4 : Temperature of vapour
TRC 5 : Regulated temperature of the pressurized water (heating group)
TR6 : Temperature into the crystalliser |
