RCT 010 - Basic temperature control trainer
The trainer is mounted on a frame and incorporates a PID type controller (Eurotherm 2216) wired and preconfigured so as to allow the regulation of the physical quantity considered (temperature).This controller allows the measurement visualization (display) and its retransmission to a computer system.It can operate either in automatic mode (autonomous regulation) or in manual mode with transmission of the command from a computer system to the actuator.The link between the regulator and the computer system is WIFI.The bench allows the study of air temperature regulation. For this, it is made up, at a minimum, of a heating body (oven), a heating resistance and a fan. The temperature is measured inside the oven and it will be regulated by a PID type regulator.
Need more information?
Contact us- Identification and study of sensors, regulator, actuator, disturbing element on the installation and on a synoptic diagram
- Study of a temperature regulation loop
- PID or auto adaptive parameters
- Controller configuration by computer interface
- Visualization of signals on supervision software
- Characteristic curves (setpoint, measurement, etc.)
1- Regulation furnace
Stainless steel tube diameter 100mm
2- Electric heating resistance
Finned resistance
Power 250W
3- Fan
Axial type fan
Adjustable speed
4- control box including
Two on / off switches fan and resistance
Electric power dimmer for controlling the resistance
A microprocessor P, PI or PID regulator with 4 / 20mA output
A WIFI output for supervision
5- Supervision software with recorder
Control and monitoring of the closed-loop control process with display of relevant data on a PC. Recording and memorization of changes over time
- Electrical supply : 230 Vac – 50 Hz – 10 A
- Electrical network : 1 phase(s) + Neutral + Earth.
- Dimensions: (LxWxH mm): 600 x 350 x 550
- weight (Kg): 20